Specifications

Project creation Sample project creation with MT Developer2 and GX Developer
5 - 10
The pop-up warning windows shown below will appear:
Click Yes. Then close the "Q parameter setting" windows by clicking End confirming the chosen
setting.
Transfer programs and parameters to the PLC controller using the setting in the screenshot below.
Please refer to "Transfer setup" (section 5.2.1) for further information on transfer setup setting and
to "Writing project to the Motion/PLC CPU" (section 5.2.3) of this quick-start guide for further
information on writing/reading programs.
! Enjoy your program!
Cycle the power supply of Q170MCPU and MR-J3 servo both.
According to the program, you created, the motor will automatically rotate 1 revolution in both
directions. The movement will be stopped by using RUN/STOP switch at the Q170MCPU front
panel.