Specifications
Start-up and trial operation Software installation
4 - 4
4.2 Software installation
4.2.1 Programming software
Install all of the software listed in the table below.
4.2.2 Operating system (OS)
As the OS software is not pre-installed, the first step before using the system is installing it into Motion
CPU.
This section explains the method for displaying the installation screen and install the OS.
Install one of the following OS.
Product Detail
MELSOFT MT Works2 (MT Developer2) Ver. 1.05F or later
GX Developer2) Ver. 8.48A or later
MR Configurator (optional) Ver. C2 or later
Tab. 4-1: Software
Motion CPU Operating system Detail
Q170MCPU
SV13 (SW8DNC-SV13QG) Conveyor assembly use
SV22 (SW8DNC-SV22QF) Automatic machinery use
Q172DCPU
SV13 (SW8DNC-SV13QD) Conveyor assembly use
SV22 (SW8DNC-SV22QC) Automatic machinery use
Q173DCPU
SV13 (SW8DNC-SV13QB) Conveyor assembly use
SV22 (SW8DNC-SV22QA) Automatic machinery use
Tab. 4-2: Assignment of operating system to motion controller