Specifications

Mounting and wiring SSCNET III connection
3 - 14
3.3.5 Setting the axis No. and axis select switch of servo amplifier
Axis No. is used to set the axis number of servo amplifiers connected to SSCNET III motion bus in the
program. Axis No. of 1 to 16 can be set.
Axis No. is set in the system setting of MT Developer2. Axis No. (1 to 16) is allocated and set for the set-
ting axis number (d01 to d16) of servo amplifier.
Since the axis number (d01 to d16) of servo amplifier on the system setting screen corresponds to axis
select rotary switch (0 to F) of servo amplifier, set the axis select rotary switch referring to the table be-
low (Tab. 3-6).
Fig. 3-13: Setting the axis No.
dno.
SSCNET III
channel
Axis select
rotary switch of
servo amplifier
dno.
SSCNET III
channel
Axis select
rotary switch of
servo amplifier
d01 1 "0" d09 1 "8"
d02 1 "1" d10 1 "9"
d03 1 "2" d11 1 "A"
d04 1 "3" d12 1 "B"
d05 1 "4" d13 1 "C"
d06 1 "5" d14 1 "D"
d07 1 "6" d15 1 "E"
d08 1 "7" d16 1 "F"
Tab. 3-6: Correspondence between dno.s and axis select switches of servo amplifier
NOTE The dno. represents the station number, which is set by the rotary switch at the servo amplifier.
Setting display of axis No. Axis select switch
(Servo amplifier)
Set the axis No. relative to axis number (dno.).