Manualshelf

Instruction manual

ManualsBrandsMitsubishi ManualsHome building and DecorMOTION CONTROLLERS Q172DCPU
31323334353637383940
4 - 4
4 POSITIONING DEDICATED SIGNALS
POINT
(1) Total number of user device points
4704 points
(2) (Note-1) : Do not set M4000 to M5487 as the latch range in virtual mode.
(3) (Note-2) : This signal occupies only the area of the axis set in the mechanical
system program. The unused axis areas in the mechanical system
program can be used as an user device.
(4) (Note-3) : The cam axis command signal and smoothing clutch complete signal
can be set as the optional device at the parameter.
(5) This manual describes only details for internal relays used in the virtual mode. If
it is required, refer to the "Q173DCPU/Q172DCPU Motion controller
(SV13/SV22) Programming Manual (REAL MODE)".