Instruction manual

3 - 2
3 PERFORMANCE SPECIFICATIONS
Table 3.1 Motion CPU Performance Specifications (Virtual Mode) (Continued)
Item Q173DCPU Q172DCPU
Interpolation functions Linear interpolation (2 to 4 axes), circular interpolation (2 axes)
Control methods
PTP (Point to Point) control, speed control, fixed-pitch feed, constant-speed control,
position follow-up control
Method
PTP control : Selection of absolute or incremental data method
Fixed-pitch feed : Incremental data method
Constant-speed control : Both absolute and incremental data method can be used together
Position follow-up control : Absolute data method
Position command Address setting range : –2147483648 to 2147483647 [PLS]
Positioning
Speed command Speed setting range : 1 to 2147483647 [PLS/s]
Acceleration-fixed acceleration/deceleration Time-fixed acceleration/deceleration
Acceleration time : 1 to 65535 [ms]
Deceleration time : 1 to 65535 [ms]
Acceleration/deceleration time:1 to 5000 [ms]
(Only constant-speed control is possible.)
Automatic
trapezoidal
acceleration/
deceleration
Acceleration/
deceleration
control
S-curve
acceleration/
deceleration
S-curve ratio : 0 to 100[%]
JOG operation function Provided
M-function (with mode) M-code output function provided, M-code complete wait function provided
Virtual servomoto
r
Manual pulse generator operation
function
(Test mode only)
Up to 3 units can be connected.
Up to 3 axes can be operated simultaneously.
Setting of magnification : 1 to 10000
Setting of smoothing magnification provided.
(Note-1) : When the TREN input signal is used as "external input mode clutch", the high speed reading function cannot be used.
(Note-2) : Capacity matching the servo program for real mode.
(Note-3) : Relation between a resolution per cycle of cam and type are shown below.
Resolution per cycle 256 512 1024 2048
Type 256 128 64 32