Instruction manual

8 - 1
8
8 OUTPUT MODULE
8. OUTPUT MODULE
The command pulse output from drive module is input to output module via the
transmission module.
The travel value of servomotor is controlled by the command pulse from output
module.
There are following four output modules.
The parameters in accordance with that mechanism is set if necessary.
• Roller.................... Section 8.1
• Ball screw............. Section 8.2
• Rotary table.......... Section 8.3
• Cam ..................... Section 8.4
(1) Output module types
Output module types are shown below.
Module Details Applications
Roller
The speed control is executed with
the final output (axis).
Roller
Ball screw
The linear position control is
executed with the final output
(axis).
Ball screw
Rotary table
The angle control is executed with
the final output (axis).
Rotary table
Cam
The electronic cam operation is
executed with the final output
(axis).
Cam
(Electronic cam)