Motors Air Conditioning Control System Operating Manual

5
1.3 Installation
There are two Maintenance Tool setup methods:
Method 1) New setup.(See Section 1.3.1)
Method 2) Upgrading with existing setup.(See Section 1.3.2)
1.3.1 Setting Up the Maintenance Tools (New setup)
To set up Maintenance Tools, follow the 3 steps below.
Step 1) Setting up of MSDE
Step 2) Setting up of database
Step 3) Setting up of
Maintenance Tools
Step 1) Setting up the MSDE
Execute “SETUP.exe” located in SetUp ¥1_MSDE4VS
in the
folder of CD-ROM.
Double clicking on “SETUP.exe” with the explorer displays the
MSDE setup screen as shown right.
PC is reset automatically after completing installation of MSDE.
After closing other application software, click [OK] and start
installation.
* To stop setting up, click on [Cancel] button.
The setting up processing requires for about 2-3minutes
.
If processing progresses to 100%, the screen in the right will be
displayed. Clicking on [OK] resets PC automatically. Please
carry out STEP2 after PC's starting.
Step 2) Setting up the database
Execute “Setup.bat” located in the folder of
SetUp ¥2_DB_SETUP
” of CD-ROM.
Double clicking on “Setup.bat” with the explorer displays
the command prompt screen.
The setting up processing ends within about 10 seconds
- 3 minutes
.
After ending of the setting up, “Press any key to continue …”
is displayed. Pressing any key closes the command prompt
screen.
Request
•For setting up, be sure to practice 3 steps in order.
Otherwise, Maintenance Tools will not operate normally.
•Before setting up, be sure to log in with the log-in name authorized as administrator.
Notice
•Before Setting up the MSDE, restart your computer and Ending software for application program
and Anti-Virus.
: After finishing Step 1, PC restarts automatically.
(Restarting PC is essential before going to Step 2.)
Notice
A
fter setting up MSDE, PC is designed to automatically reset. However, if this setting up is executed without
finishing other application software, PC may not be reset automatically. In this case, reset PC manually. Afte
r
restarting, go to Step 2. Without restarting PC, Maintenance Tool can not be set up unless replacing OS
itself.
Caution
Please refer to also 1.3.4 RE:
Change of computer name on PC.