Specifications

24
7-2-3. Wiring connections
All electric work must be performed by a qualified
electrician according to the local regulations, standards,
and the instructions detailed in this manual.
Capacity shortage to the power supply circuit or improper
installation may result in malfunction, electric shock,
smoke, or fire.
To reduce the risk of injury or electric shock, switch off the
main power before performing electrical work.
To reduce the risk of damage to AHC, malfunctions,
smoke, or fire, do not connect the power cable to the signal
terminal block.
IMPORTANT
● To avoid damage to AHC, do not connect an AC power cable to the terminal block.
● Be careful not to injure your hands with sharp edges of the AHC ADAPTER cover.
7-2-3-1. Removing the cover to access the wiring
Unscrew the two screws on the cover to remove it as shown in the figure below.
XS
Fig. 7-7