Specifications

21
Method 1: Installation using L-fittings
1. Have a metal control box ready. (Minimum steel thickness: 1 mm (3/64 in))
2. Attach the supplied two L-fittings to the AHC ADAPTER with the supplied M3 screws. (Fig. 7-3)
3. Properly install the AHC ADAPTER with the M4 screws (field-supplied) horizontally inside the metal control box. (Fig. 7-3)
XS
M3
(6 mm (1/4 in))
M3
(6 mm (1/4 in))
M4
M4
Fig. 7-3
Note
● Each L-fitting must be attached to the AHC ADAPTER with two M3 screws.
● The AHC ADAPTER to which the L-fittings are attached must be fixed to the metal control box with total of two M4 screws
to prevent it from falling.
● The surface on which the AHC ADAPTER will be installed needs to be strong enough to support its weight.
● Fix the AHC ADAPTER in place with the dedicated fixtures if the AHC ADAPTER slides aside.
● Leave the AL2-CAB BOARD (Fig. 5-1) wrapped in bubble wrap until after AHC ADAPTER has been installed in the metal
control box.