Operation Manual

Disk Handling 7-4
Disk Handling
Inserting and Removing Disks
This section explains how to insert music
CDs, MP3/WMA disks (CD-R/RW), and
DVDs (DVD-VIDEO) into the MMCS.
Inserting a disk
1 Press the [OPEN] key
Monitor Panel
eng_mngi474a
Slide open the monitor panel to reveal the disk slot.
2 Insert a disk
eng_mngi475a
Disk
Label side
Make sure the disk label is on top when inserting into
the slot. When the disk is taken automatically, release
your hand.
Removing a disk
1 Press the [DISC ] key
mngi477a
DISC
The disk is ejected automatically to the disk removal
position. Remove the disk.
2 Press the [OPEN] key
Slide the monitor panel closed to return the MMCS to
its original state.
CAUTION
• When inserting or removing disks, operate it while
parked in a safe location, and do not stop in no-
parking zones.
• Do not insert hands, fi ngers, or other foreign objects
into the slot. This may cause injury, smoke, or fi re.
• Take care not to pinch your fingers, etc., when
opening or closing the monitor panel.
•
Make sure the monitor panel is closed while driving.
• Do not leave the monitor panel open, and do not
place any objects on top of the monitor panel.
• The monitor panel cannot be closed when a disk
is in the disk removal state (i.e., partially ejected)
from the disk slot, but depending on the disk state,
it may not be possible to detect that a disk has
been ejected. If the monitor panel is closed while
an undetected ejected disk is still in the slot, there
is a risk that either the disk or the device will be
damaged. When closing the monitor panel, check
that there is no ejected disk in the disk slot before
closing.
• Do not press the [DISC] key while the monitor
panel is opening or closing. The disk or the MMCS
may be damaged.