Motors Automobile User Manual

ABS <2WD> -
Troubleshooting
35B-7
With the ABS Warning Lamp
1. Use the special tool to earth terminal (1) (diagnosis control terminal) of the diagnosis connector.
(Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points.)
2. Stop the engine.
3. Turn o n the stop lamp switch. (Depress the brake.)
4. After carrying out steps 1. to 3., turn the ignition switch to ON. Within 3 seconds after turning the
ignition switch to ON, turn off the stop lamp switch (release the brake). Then, turn the stop lamp
switch on and off a total of 10 times.
NOTE
If the ABS-ECU function has been stopped because of fail-safe operation, it will not be possible
to erase the diagnosis codes.
1st 2nd 3rd 4th 5th 6th 7th 8th 9th 10th
Within
1
second
Within
1
second
Within
1
second
Within
1
second
Within
1
second
Within
1
second
Within
1
second
Within
1
second
Within
1
second
Within
1
second
1 se-
cond
Ignition switch
ON
OFF
Stop lamp switch
ON
OFF
ABS warning lamp
ON
OFF
ABS-ECU memory
Within 3
seconds
Erasing of
ABS-ECU
diagnosis
codes
complete.