Specifications

BCN-B11127-479*

5.4 Manual operation mode

For machine adjustment, home position matching, etc., jog operation or a manual pulse generator may be

used to make a motion to any position.

5.4.1 Jog operation

(1) Setting

Set the input signal and parameters as follows according to the purpose of use. In this case, the point

table No. selection 1 to 5 signals (DI0 to DI4) are invalid:

Item Setting Method Description

Manual operation mode selection Automatic/manual selection signal (MDO) Open MDO-SG (OFF).

Servo motor rotation direction Parameter No.1 Refer to (2) in this section.

Jog speed Parameter No.13 Set the speed of the servo motor.

Acceleration/deceleration time constant Point table No.1

Use the acceleration/deceleration

time constants in point table No.1.

(2) Servo motor rotation direction

Servo Motor Rotation Direction

Parameter No. 1 Setting

Forward Rotation Start (ST1) ON Reverse Rotation Start (ST2) ON

0 CCW rotation CW rotation

1 CW rotation CCW rotation

ST1:ON

CCW

ST2:ON

CCW

ST1:ON

Parameter No. 1

0 Parameter No. 1 1