Specifications

2. OPERATION
2– 24
(2) Output signal forced output
The output signal can be forced on/off independently of the servo status. This function is used
for output signal wiring check, etc. This operation must be performed in the servo off state
(SON signal off).
Operation
Call the display screen shown after power-on.
Switch on/off the signal below the lit segment.
• • •••••
The segment above CN1A-pin 18 is lit.
• • •••••
CN1A-pin 18 is switched off.
• • •••••
CN1A-pin 18 is switched on.
(CN1A-pin 18-SG conduct.)
• • •••••
Indicates the ON/OFF of the output signal. The correspondences
between segments and signals are as in the output signals of the
external I/O signal display.
(Lit: ON, extinguished: OFF)
• • •••••
CN1A
14
CN1B
6
CN1B
4
CN1A
18
CN1B
19
CN1A
19
CN1B
18
Press MODE once.
Press MODE once.
Press DOWN once.
Press UP twice.
Press UP twice.
Press SET for more than 2 seconds.
Press SET for more than 2 seconds.