Specifications
Print Data *Manual Number Revision
May,2000 IB(NA)67286-E
Addition of compliance to EC directive 1 (1), (2), (3)
Addition of 2. Cautions for appliance (1) Servo amplifier and servo
motor to be used to EC directive
Addition of (6) e.
UL/C-UL Standard (1) Addition of servo amplifier and servo motor
to be used
UL/C-UL Standard (4) Change in flange table
UL/C-UL Standard (2) Addition of optional parts and peripheral
devices
Section 1-1-2 (1) Change in rating name plate
Section 2-3-5 (4) Change of parameter detail description
No. 2 initial value to 0002
Addition of some text to parameter No. 47
Addition of some text to parameter No. 48
Chapter 3 Addition of caution drawing
Section 3-1-2 (4)q Change to emergency stop
Section 3-1-2 (4)w Change in max. pulse width of detector Z-
phase pulse to 400
Section 3-1-3 (6) Addition to figure of timing chart for switching
Section 3-1-4 (1) Partial change in drawing of digital interface
D1-1
Section 3-1-4 (2) Partial change in figure
Section 3-1-4 (3) Partial change in figure
Section 3-2-4 (1) Change of servo motor side connector to
1-172169-9
Section 3-3 Partial deletion of figure
Section 3-6 Partial change in figure of timing chart at the
time of occurrence of alarm
Section 3-7 Addition of point
Section 3-7 (1) Partial change in connection diagram
Section 3-7 (3) (a) Change in text
Section 3-7 (3) (b) Partial change in figure
Section 3-7 (3) (c) Partial change in figure
Section 3-7 (3) (d) Partial change in figure
Section 4-2 (4) Deletion of shaft allowable load table (kgf)
Section 6-1-2 (2)w Change of signals listed in relay terminal block
side table of detector cable connection
diagram to those abbreviated
Section 6-1-3 Addition of point
Section 6-2-6 (2) Change in diode mounting drawing
Section 8-1-1 (2) Partial change in figure
Addition of some text
Section 8-2-2 Addition of A. 25 Trouble, Cause Remedy
Section 9-3 (1) Deletion of Table 9-2 (kgf.cm)
Section 10-1 (2) Deletion of Table (kgf.cm)
Section 10-5-2 (1) Change in all HC-MF series
Section 10-5-2 (2) Change in HC-MF-UE series
Section 10-5-2 (5) Change in HC-UF3000 rpm series
Section 10-5-3 (3) Change of servo motor detector plug
*The manual number is given on the bottom left of the back cover.
REVISIONS