Instruction manual

3 - 5

3. LOAD SIDE ENCODER

(3) For ST741A or ST743A

(a) Cable structure

Prepare a cable based on the following structure diagram.

CN2L

Servo amplifier

Personal computer

Software for

signal adjustment

Conversion unit

For the signal adjustment and confirmation, connect the following equipments. (Note 2)

Linear encoder

ST741A

Load side encoder cable

Head cable

Cable

Load side encoder cable Head cable

When using an

optional cable

1) Options manufactured by Mitutoyo Corporation (This should be prepared by

the customer.) (Note 1)

Part No.06ACF117A: 5m

Part No.06ACF117B: 10m

When producing a

load side encoder

cable

2) Connector set MR-J3CN2

(Option manufactured by

Mitsubishi Electric

Corporation)

(Refer to section 3.4.)

3) Junction connector (This should be

prepared by the customer.)

D-SUB (female) 15 Pin shell: HDAB-15S’

Plug case: HDA-CTH

(manufactured by HIROSE ELECTRIC

CO., LTD)

Accessories for linear encoder

Cable length: 1m

Note 1. For details, contact with Mitutoyo Corporation .

2. When mounting ST741A

ST743A, a personal computer (with RS-232C port) for the signal adjustment and confirmation, and a

software and conversion unit for signal adjustment are required. For details, contact with Mitutoyo Corporation.