Instruction manual

5 - 20
5. PARAMETERS
No. Symbol Name and Function
Initial
Value
Unit
Setting
Range
PE28 For manufacturer setting 0000h
PE29
Do not change this value by any means.
0000h
PE30 0000h
PE31 0000h
PE32 0000h
PE33
0000h
PE34 **FBN2
Fully closed loop control feedback pulse electronic gear 2 numerator
Used to set the numerator of the electronic gear to the motor encoder pulse. Set the
electronic gear so that the number of pulses for one servo motor revolution is converted to
the resolution of the load side encoder.
When the set value is "0", it is identified as "1" inside.
1 0
to
32767
PE35 **FBD2
Fully closed loop control feedback pulse electronic gear 2 denominator
Used to set the denominator of the electronic gear to the motor encoder pulse. Set the
electronic gear so that the number of pulses for one servo motor revolution is converted to
the resolution of the load side encoder.
When the set value is "0", it is identified as "1" inside.
1 0
to
32767
PE36
For manufacturer setting
0.0
PE37
Do not change this value by any means.
0.00
PE38 0.00
PE39 0000h
PE40
0000h