Instruction manual

5 - 17
5. PARAMETERS
5.5 Extension control parameters (No.PE
)
POINT
Parameter whose symbol is preceded by * is made valid with the following
conditions.
* : Set the parameter value, switch power off once after setting, and then switch
it on again, or perform the controller reset.
**: Set the parameter value, switch power off once, and then switch it on again.
5.5.1 Parameter list
No. Symbol Name Initial value Unit
PE01 **FCT1 Fully closed loop selection 1 0000h
PE02 For manufacturer setting 0102h
PE03 *FCT2 Fully closed loop selection 2 0003h
PE04 **FBN Fully closed loop feedback pulse electronic gear numerator 1 1
PE05 **FBD Fully closed loop feedback pulse electronic gear denominator 1 1
PE06 BC1 Fully closed loop control speed deviation error detection level 400 r/min
PE07 BC2 Fully closed loop control postion deviation error detection level 100 kpulse
PE08 DUF Fully closed loop dual feedback filter 10 rad/s
PE09 For manufacturer setting 0000h
PE10 FCT3 Fully closed loop selection 3 0000h
PE11 For manufacturer setting 0
PE12 40
PE13 FFFEh
PE14 0111h
PE15 20
PE16 0000h
PE17 0000h
PE18 0000h
PE19 0000h
PE20 0000h
PE21 0000h
PE22 0000h
PE23 0000h
PE24 0000h
PE25 0000h
PE26 0000h
PE27 0000h
PE28 0000h
PE29 0000h
PE30 0000h
PE31 0000h
PE32 0000h
PE33 0000h
PE34 **FBN2 Fully closed loop feedback pulse electronic gear numerator 2 1
PE35 **FBD2 Fully closed loop feedback pulse electronic gear denominator 2 1
PE36 For manufacturer setting 0.0
PE37 0.00
PE38 0.00
PE39 0000h
PE40 0000h