Instruction manual

2 - 15
2. LINEAR SERVO MOTOR
Procedure 4. Securely fix with bolts the secondary side (magnet) fixed as temporary joint.
Secondary side (magnet) to be a mounting standard
(3) Mounting the primary side (coil)
CAUTION
To avoid the danger caused by suction, which is generated between the primary
side (coil) and the secondary side (magnet) by the permanent magnet, it is
recommended to mount the primary side (coil) in the position free from the
secondary side (magnet) as shown in this section.
When mounting the primary side (coil) over the secondary side (magnet)
unavoidably, use the material handling equipment such as crane which is fully
competent to sustain the load of suction, etc.
When sliding the primary side (coil) to move over the secondary side (magnet)
after setting, pay full attention to the suction generated.
Procedure 1. Mount a part of the secondary side (magnet).
Procedure 2. Mount the primary side (coil) in the position free from the secondary side (magnet).
Procedure 3. Move the primary side (coil) over the secondary side (magnet) mounted.
Confirm that the primary side (coil) does not contact the secondary side (magnet).
Procedure 4. Mount the rest of the secondary side (magnet).