Instruction manual

A - 3
CAUTION
Only the voltage specified in the Instruction Manual should be applied to each terminal, Otherwise, a
burst, damage, etc. may occur.
Connect the terminals correctly to prevent a burst, damage, etc.
Ensure that polarity ( , ) is correct. Otherwise, a burst, damage, etc. may occur.
Take safety measures, e.g. provide covers, to prevent accidental contact of hands and parts (cables, etc.)
with the servo amplifier heat sink, regenerative brake resistor, linear servo motor, etc. since they may be
hot while power is on or for some time after power-off. Their temperatures may be high and you may get
burnt or a parts may damaged.
The linear servo motor installation operators and machine operators must not work wearing electronic
devices (watch, calculator, personal computer, etc.) and magnetic recording media (IC card, magnetic
card, floppy disc, etc.) and must not bring them around a magnetic. The magnetic influence may cause
the operation failure or malfunction.
When the protective function is operated, turn the power off immediately to eliminate its cause, and then
turn it on again. If the linear servo motor is continued operating without eliminating the cause, it may run
out of control or malfunction, which may cause a damage and injury.
Securely attach the linear servo motor to the machine. If attach insecurely, it may come off during
operation.
4. Additional instructions
The following instructions should also be fully noted. Incorrect handling may cause a fault, injury, electric shock,
etc.
(1) Transportation and installation
CAUTION
Transport the products correctly according to their weights.
Stacking in excess of the specified number of products is not allowed.
Do not carry the linear servo motor by the cables, shaft or encoder.
Do not hold the front cover to transport the servo amplifier. The servo amplifier may drop.
Install the servo amplifier in a load-bearing place in accordance with the Instruction Manual.
Do not climb or stand on servo equipment. Do not put heavy objects on equipment.
The servo amplifier and linear servo motor must be installed in the specified direction.
Leave specified clearances between the servo amplifier and control enclosure walls or other equipment.
Do not install or operate the servo amplifier and linear servo motor which has been damaged or has any
parts missing.
Provide adequate protection to prevent screws and other conductive matter, oil and other combustible
matter from entering the servo amplifier and linear servo motor.
Do not drop or strike servo amplifier or linear servo motor. Isolate from all impact loads.
The protection method of the linear servo motor is IP00. Take necessary measures against dust, oil, etc.
(Refer to Section 2.1.2 Installation direction.)
When mounting the secondary side (magnet), use nonmagnetic tools.
Securely attach the linear servo motor to the machine. If attach insecurely, the linear servo motor may
come off during operation.