Instruction manual

5 - 15
5. OPERATION AND FUNCTIONS
1048576pulse
ON
OFF
Home position reference position
Linear servo motor position
Home position return speed
Home position return direction
Creep speed
(Note)
1048576 pulses n times
Linear encoder home position
Home position
Home position return operation
Zeroing dog signal
Note. Can be changed with the parameter No. PS01.
(2) When the linear encoder home position does not exist in the home position return direction
If the home position return is performed from the position where the linear encoder does not exist in the
home position return direction, the controller will be a home position return error. Error contents differ
depending on types of controller. In this chase, move it once with the JOG operation from the controller,
etc. to the stroke end on the opposite side of the home position return direction, and then perform the home
position return.
ON
OFF
Zeroing dog signal
Linear servo motor position
Home position return speed
Home position return direction
Creep speed
JOG operation
Stroke end
Linear encoder home position
Home position
Home position returnable area
Home position nonreturnable area
Home position return operation
POINT
For surely carrying out the home position return, make sure to execute the
home position return after moving it to the stroke end on the opposite side
with the JOG operation from the controller, etc.
Change the setting value for the third digit of parameter No. PS01 according
to the linear encoder resolution.