Instruction manual

3 - 45

3. SIGNALS AND WIRING

3.13 Control axis selection

POINT

The control axis number set to rotary axis setting switch (SW1) should be the

same as the one set to the servo system controller.

Use the rotary axis setting switch (SW1) to set the control axis number for the servo. If the same numbers

are set to different control axes in a single communication system, the system will not operate properly. The

control axes may be set independently of the SSCNET

cable connection sequence.

Rotary axis setting switch (SW1)

Down

Test operation select switch (SW2-1)

Set the test operation select switch to the "Up" position, when

performing the test operation mode by using MR Configurator

(Servo configuration).

Spare (Be sure to set to the "Down" position.)

(Note) SW2

Note. This table indicates the status when the switch is set to "Down".

(Default)

Spare Rotary axis setting switch (SW1) Description Display

0Axis No.101

1Axis NO.202

2Axis NO.303

3Axis NO.404

4Axis NO.505

5Axis NO.606

6Axis NO.707

7Axis NO.808

8Axis NO.909

9Axis NO.1010

AAxis NO.1111

BAxis NO.1212

CAxis NO.1313

DAxis NO.1414

EAxis NO.1515

Down

(Be sure to set to the

"Down" position.)

FAxis NO.1616