Instruction manual

10 - 5
10. CHARACTERISTICS
(Note 2)
Servo amplifier-generated heat[W]
Area required for
heat dissipation
Servo amplifier Servo motor
(Note 1)
Power supply
capacity[kVA]
At rated torque With servo off [m
2
]
HF-SP702 10.0 300 25 6.0
HA-LP702 10.6 300 25 6.0
HA-LP601 10.0 260 25 5.2
MR-J3-700B
HA-LP701M 11.0 300 25 6.0
HC-LP11K2 (4) 16.0 530 45 11.0
HC-LP801 (4) 12.0 390 45 7.8
HC-LP12K1 (4) 18.0 580 45 11.6
MR-J3-11KB
HC-LP11K1M (4) 16.0 530 45 11.0
HC-LP15K2 (4) 22.0 640 45 13.0
HC-LP15K1 (4) 22.0 640 45 13.0
MR-J3-15KB
HC-LP15K1M (4) 22.0 640 45 13.0
HC-LP22K2 (4) 33.0 850 55 17.0
HC-LP20K1 (4) 30.1 775 55 15.5
HC-LP25K1 37.6 970 55 19.4
MR-J3-22KB
HC-LP22K1M (4) 33.0 850 55 17.0
Note 1. Note that the power supply capacity will vary according to the power supply impedance. This value assumes that the power
factor improving reactor is not used.
2. Heat generated during regeneration is not included in the servo amplifier-generated heat. To calculate heat generated by the
regenerative brake option, in Section 11.2.