Specifications

MITSUBISHI
MITSUBISHI
MITSUBISHI
MITSUBISHI
1SD75P3
A
AX2
BSY
MODE
AX3
AX1
RS-422
MITSUBISHI
A171SHCPU
33
MITSUBISHI ELECTRI
C
MELSERVO MR-J2S
SERVO AMPLIFIERS
BASICS
Connections with peripheral equipment
The figure below shows the linking of a
motion controller system. The motion
controllers of the series MELSEC A and
MELSEC System Q as well as the servo
amplifiers are linked via the high-speed
network SSCNET.
The SSCNET network delivers high relia-
bility and less wiring. SSCNET series sys
-
tems brings you the best in easy-to-use
motion control applications.
Further information on the motion control
systems by Mitsubishi Electric is included
in the Technical Catalogues to motion
controllers of the series MELSEC A and
MELSEC System Q.
CN1B for connecting SSCNET (next)
Connects the next axis servo-amp or terminal connec
-
tor (MR-A-TM)
CN1A for connecting SSCNET (previous)
CN3 for RS-232 communication (option)
CN3 for RS-232C communication (option)
Connects the unit to the user's personal computer,
enabling the user to monitor conditions, display
graphs, and perform test operation. Setup software
and dedicated cable are available too.
Battery compartment (option)
A battery (MR-BAT) is installed in the holder when
using as an absolute system.
Display panel
Displays servo-amp status and alarm numbers
Axis setting section
Used to select an axis
Terminal connector (option)
Regeneration unit (option)
Install this unit in situations involving frequent
regeneration and large load inertia. Disconnect P
and D when using this optional unit.
Charge lamp
Illuminates when the main circuit power supply is on.
Do not plug or unplug the power lines when this lamp
is on.
Connector
Motor
Regeneration
unit
Connector
SSCNET
Servo amplifier
MR-J2S-첸B
SSCNET
Motion Controller
MELSEC A: A171SH, A172SH or A173UH,
MELSEC System Q: Q172CPUN, Q173CPUN
Positioning modules
MELSEC A: e.g. A1SD75M,
MELSEC System Q: e.g. QD75M