Specifications

19
MITSUBISHI ELECTRI
C
MELSERVO MR-J2S
Operation / Menu Guide to the Display
Button
UP button
DOWN button
Mode
Current alarm
Last alarm
Second alarm in past
Third alarm in past
Fourth alarm in past
Sixth alarm in past
Fifth alarm in past
Parameter
error number
Torque limit voltage
Torque command voltage [mV]
Sequence
External I/O signal
display
Output signal
forced output
Test operation
Jog feed
Test operation
positioning operation
Test operation
Motor-less operation
Test operation Machine
analyzer operation
Sofware version H
Sofware version L
Automatic VC offset
Motor series ID
Motor type ID
Encoder ID
Cumulative feedback
pulses [pulse]
Motor speed
[r/min.]
Droop pulses
[pulse]
Cumulative command
pulses [pulse]
Command pulse
frequency [kkps]
Speed command voltage
Speed limit voltage [mV]
Regenerative load
ratio [%]
Effective load
ratio [%]
Peak load
ratio [%]
Instantaneous torque
[%]
Within one-revolution
position, low [pulse]
Within one-revolution
position, high [100 pulses]
ABS counter
[rev]
Load intertia moment
ratio [times]
Bus voltage [V]
Status display
Diagnosis
Alarm
Basic parameters
Expansion parameters 1 Expansion parameters 2
Parameter No. 0
Parameter No. 1
Parameter No. 18
Parameter No. 19
Parameter No. 20
Parameter No. 21
Parameter No. 48
Parameter No. 49
Parameter No. 50
Parameter No. 51
Parameter No. 83
Parameter No. 84
UP
Down
Pressing the MODE button causes the dis
-
play mode to change one step at a time in
the sequence illustrated below.
Note: Press the SET button to display
actual data in status display mode.
SERVO AMPLIFIERS
BASICS