Specifications

18
MITSUBISHI ELECTRI
C
MELSERVO MR-J2S
Operating Elements
MODE UP DOWN SET
 Mode:
Used to switch between display modes
 Up/ Down:
Used to change display content and
re-enter parameter data
 Set:
Used to set parameters for auto-tuning
and for switching to the test screen
 Display:
5-digit, 7-segment display panel. Displays
operating status, parameters, etc.
 Battery holder/ connector:
Using to connect the battery for absolute
position data backup.
Easier to operate than ever before
The display and setting sections are easy to operate. And with the
advanced features it encorporates, the MR-J2S is easy to start up.
 I/O signal connector (CN1A):
Used to connect digital I/O signals
 I/O signal connector (CN1B):
Used to connect digital I/O signals
 Encoder connector (CN2):
Used to connect the servo motor/ encoder
 Communication connector (CN3):
Used to connect a personal computer or as
analog monitor output
햻 Charge lamp:
Lit to indicate that the main circuit is
charged. While this lamp is lit, do not
reconnect the cables.
햽 Name plate
햾 Main circuit terminal block (TE1):
Used to connect the input power supply
and servo motor
햿 Control circuit terminal block (TE2):
Used to connect the control circuit power
supply and regenerative brake option.
헀 Protective earth terminal (PE):
Ground terminal




MR-J2S-200A or bigger
햷
햸
햹
햺
햻
햽
햾
햿
헀
MR-J2S-200A or bigger
SERVO AMPLIFIERS
BASICS