Instruction manual

Parameter Operation

MELSERVO J2-Super 4 - 13

Set the parameter value and switch power off once, then switch it on again to make that

parameter setting valid.

The values corresponds with the factory settings of the servo amplifier. Connecting it with

the servo system controller and switching power on changes them to the settings of the

servo system controller.

Setting and changing cannot be made from the peripheral software of the motion controller.

Function No. Symbol Name Initial value Unit

Customer

setting

Expansion

parameters

27 MO1 Analog output 1 offset 0 mV

28 MO2 Analog output 2 offset 0 mV

29 — Reserved 0001 —

30 ZSP Zero speed 50 r/min

31 ERZ Error excessive alarm level 80 0.1 × r

32 OP5 Function selection 5 0000 —

OP6

Function selection 6 0000 —

34 VPI

PI-/PID control switch-over position

droop

0Pulse

35 — Reserved 0 —

36 VDC Speed differential compensation 980 —

37 — Reserved 0010 —

ENR

Encoder output pulses 4000 Pulse/r

39 — Reserved 0 —

BLK

Parameter entry prohibition 0000 —

Tab. 4-12: Parameter overview (2)