Instruction manual

Operation Test operation mode

4 - 10

4.4.1 Test operation procedure

JOG operation, positioning operation, program operation, forced output

Switch power off.

Set the coding switch CS1 to „F“.

When CS1 is set to the station number and operation is performed by the servo system

controller, the test operation mode screen is displayed on the personal computer, but no

function is performed.

 Switch servo amplifier power on. When initialization is over, the display shows the following

screen:

 Perform operation with the personal computer.

Motor-less operation

Switch off the servo amplifier.

Perform motor-less operation with the personal computer. The display shows the following

screen:

Decimal point flickers