Instruction manual

Station number setting Connection

MELSERVO J2-Super 3 - 27

3.9 Station number setting

Use the coding switch (CS1) to set the station number for the servo amplifier. If the same

numbers are set to different servo amplifier in a single communication system, the system will

not operate properly. Set the switch to "F" when executing the test operation mode using the

setup-software.

NOTE

The station number set to CS1 should be the same as the one set to the servo system

controller.

Abb. 3-30:

Station number setting switch

S000972C

Setting Description

Abb. 3-31:

Station number setting

0 Station 1

1 Station 2

2 Station 3

3 Station 4

4 Station 5

5 Station 6

6 Station 7

7 Station 8

8—

9—

A—

B—

C—

D—

E—

Test operation mode or when

machine analyzer is used (refer

section 4.6.2)

CS1