Instruction manual

Filter functions Special adjustment functions
MELSERVO J2-Super 5 - 3
Parameter
● Machine resonance suppression filter (pr. 18)
Set the notch frequency and attenuation of the machine resonance suppression filter
(parameter No.18).
S000612C
Fig. 5-3: Machine resonance suppression filter setting
NOTES
If the frequency of machine resonance is unknown, decrease the notch frequency from
higher to lower ones in order. The optimum notch frequency is set at the point where
vibration is minimal.
A deeper notch has a higher effect on machine resonance suppression but increases a
phase delay and may increase vibration.
The machine characteristic can be grasped beforehand by the machine analyzer on the
setup software). This allows the required notch frequency and attenuation to be determined.
0
Frequency [Hz]
Setting
Fre-
quency
Setting
Fre-
quency
Setting
Fre-
quency
Setting
Fre-
quency
00 — 08 562.5 10 281.3 18 187.5
01 4500 09 500 11 264.7 19 180
02 2250 0A 450 12 250 1A 173.1
03 1500 0B 409.1 13 236.8 1B 166.7
04 1125 0C 375 14 225 1C 160.1
05 900 0D 346.2 15 214.3 1D 155.2
06 750 0E 321.4 16 204.5 1E 150
06 642.9 0F 300 17 195.7 1F 145.2
Attenuation [dB]
Setting Attenuation
0 40
1 14
2 8
3 4