Instruction manual

A - 8
(3) Power supply
Use a 24VDC power supply which has been insulation-reinforced in I/O.
(4) Grounding
To prevent an electric shock, always connect the protective earth terminal (E) to the servo amplifier
and always connect it to the earth (E) of the control box.
(5) Auxiliary equipment and options
(a) The circuit protector used should be the EN or IEC standard-compliant products of the models
described in Section 11.2.2.
(b) The sizes of the cables described in Section 11.2.1 meet the following requirements. To meet the
other requirements, follow Table 5 and Appendix C in EN60204-1.
Ambient temperature: 40 (104) [ ( )]
Sheath: PVC (polyvinyl chloride)
Installed on wall surface or open table tray
(6) Performing EMC tests
When EMC tests are run on a machine/device into which the servo amplifier has been installed, it
must conform to the electromagnetic compatibility (immunity/emission) standards after it has
satisfied the operating environment/electrical equipment specifications.
For the other EMC directive guidelines on the servo amplifier, refer to the EMC Installation
Guidelines(IB(NA)67310).