Instruction manual

5. PARAMETERS
I POINT 1
For any parameter whose symbol is preceded by*, set the parameter value
and switch power off once, then switch it on again to make that parameter
setting valid.
For details of the parameters, refer to the corresponding items.
The symbols in the Control Mode column of the table indxate the following modes:
P : Position control mode
S : Speed control mode
T : Torque control mode
(1) Item list
15
\
0000 P. S .T Parameter block 'BLK
19
\
0000 P. S .T Status display selection *DMD 18
\o\
Spare
\
17
\
0000 P .S .T Communication baudrate selection, alarm history clear *BPS
16
station 0 P. S . T
Station number setting *SNO
5- 2