Instruction manual
4.
Additional instructions
The following instructions should also be fully noted. Incorrect handling
may
cause a fault, injury, electric shock,
etc.
1)
Transportation and installation
A
CAUTION
Transport the products correctly according to their weights.
Stacking in excess of the specified number
of
products
is
not allowed.
Do not carry the motor by the cables, shaft or encoder.
Do
not hold the front cover to transport the controller. The controller may drop.
Install the servo amplifier in a load-bearing place in accordance with the Instruction Manual.
Do
not climb
or
stand on servo equipment.
Do
not put heavy objects on equipment.
The controller and servo motor must be installed in the specified direction.
Leave specified clearances between the servo amplifier and control enclosure walls
or
other equipment.
Do
not install or operate the servo amplifier and servo motor which has been damaged
or
has any parts
Provide adequate protection to prevent screws and other conductive matter,
oil
and other combustible
Do
not drop or strike servo amplifier or servo motor. Isolate from all impact loads.
Use the servo amplifier and servo motor under the following environmental conditions:
missing.
matter from entering the servo amplifier.
Environment
Conditions
Servo
Amplifier Servo Motor
Ambient
temperature
I
..
Ambient humiditv
~ ~~ ~
Storage
temperature
Storage humidity
Ambience
0
to
+55
(non-freezing)
32
to
131 (non-freezing)
0
to
40
(non-freezing)
Indoors (no direct sunlight) Free from corrosive
qas,
flammable
gas,
oil mist, dust and dirt
90%RH or less (non-condensing)
5
to
158
(non-freezing)
4
to
149
(non-freezing)
-15
to
+70
(non-freezing) -20
to
+65 (non-freezing)
80%RH
or
less
(non-condensing)
90%RH
or less (non-condensing)
32
to
104 (non-freezing)
Altitude
Vibration
Max.
1
OOOm
(3280
ft)
above sea level
[m/s2]
X
.
Y
:
64
HC-AQ Series 19.4 or less
[Ws2]
X
.
Y
:
19.6
{2G)
HC-AQ Series
5.9
(0.6G)
or less
A-
3