Instruction manual
1.
To
prevent electric shock, note the following:
AWARNING
Before wiring or inspection, switch power off and wait for more than
10
minutes. Then, confirm the voltage is
safe with vottage tester. Otherwise, you may get an electric shock.
Connect the servo amplifier and servo motor
to
ground.
Any person who is involved in wiring and inspection should be fully competent to
do
the work.
Do not attempt to wire the servo amplifier and servo motor until they have been installed. Otherwise, you
may get an electric shock.
Operate the switches with dry hand to prevent an electric shock.
The cables should not be damaged, stressed loaded,, or pinched. Otherwise,
you
may get an electric
shock.
2.
To
prevent
fire,
note the
following:
A
CAUTION
Do
not install the servo amplifier, servo motor and regenerative brake resistor on or near combustibles.
Otherwise a fire may cause.
When the servo amplifier has become faulty, switch off the main servo amplifier power side. Continuous
flow of a large current may cause a fire.
3.
To
prevent
injury,
note the
follow
A
CAUTION
Only the voltage specified in the Instruction Manual should be applied to each terminal,, Otherwise,,
a
burst,,
damage,, etc. may occur.
Connect the terminals correctly to prevent a burst,, damage,, etc.
Ensure that polarity (+,
-)
is correct. Otherwise, a burst, damage, etc. may occur.
During power-on or for some time after power-off, do not touch the servo motor. Their temperatures may be
high and you may get burnt.
A-
2