Instruction manual
2.
INSTALLATION
2.3 Keep
out
foreign
materials
(1)
When instalhg the unit
in
a control box, prevent
drill
chps and wire fragments from entering the
servo amphfier.
(2)
Prevent
oil,
water, meuc dust, etc. from entering the servo ampaer through openings
in
the control
(3)
When instalhg the control box
in
a place where there are toxic gas,
dxt
and dust, provide positive
pressure
in
the control box
by
forcing
in
clean air
to
prevent such materials fiom entering the control
box.
box or a fan installed on the ceding.
2.4
Cable
stress
(1)
The way
of
clamping the cable must be
fdy
examined so that flexing stress and cable's own weight
stress are not applied
to
the cable connection.
(2)
In any application where the servo motor moves, the cables should be free from excessive stress. For
use in any application where the servo motor moves, run the cables
so
that their flexing portions fall
with the optional motor cable range. Fix the motor cable and power lead of the servo motor.
(3)
Avoid any probabhty that the cable sheath might be cut by sharp chps, rubbed by a machme corner
or
(4)
For installation on a machme where the servo motor
will
move, the 5exing radms should be made as
stamped by workers or vehicles.
large as possible. Refer to section
11.4
for the 5exing Me.
2- 3