Instruction manual

1. FUNCTIONS AND CONFIGURATION
1.5 Parts Identification
Display
The four-digit, seven-segment LED shows the servo
status and alarm number.
Operation section
Used
to perform status display, diagnostic, alarm and
parameter operations.
MODE UP DOWN SET
-
1 data.
'-used to set parameter
Used to change the
display or data in each
mode.
I Used to change the
mode.
I/O signal connector (CN1 A)
Used to connect digital
I/O signals.
I/O signal connector (CN1 6)
Used to connect digital I/O signals.
Name plate
~ ~~
Servo motor connector (CNP2)
Connector for connection of the servo motor.
Power input connector (CNP1)
Used
to connect the input power supply/control circuit
power supply/RS-422.
Communication connector ICNP3)
Used for connection with a 'prsonal computer
(RS-232C).
Earth (E) terminal (4)
To conform to the EN Standard, fit the supplied earth
terminal for grounding.
Refer To
Chapter6
Chapter6
Section3.3
Section3.3
Sectionl.3
Section3.3
;ection10.2.'
;ection12.1.'
Section3.3
;ectionl0.2.'
Section3.3
;ection10.2.'
;ection12.1.:
Section3.9
1- 4