Instruction manual
13.
COMMUNICATION FUNCTIONS
13.12.3 Parameter
(1
)
Parameter read
Read the parameter setting.
1) Transmission
Transmit command [0][5] and the data
No.
corresponding
to
the parameter
No.
The data
No.
is expressed in hexadecimal equivalent
of
the data
No.
value corresponds to the
parameter number.
2)
Reply
The slave station sends back the data and processing dormation
of
the requested parameter
No..
I,
Data is transferred in hexadecimal
Decimal point position
[O]:
No
decimal point
[l]:
Lower first digit
(21:
Lower second digit
[3]:
Lower third digit
[4]:
Lower fourth digit
[5]:
Lower fifth digit
i
Display type
0:
Used unchanged
in
hexadecimal
1:
Conversion into decimal required
Parameter write type
0:
Valid after write
1 :
Valid when power is switched on again after write
Read enable/disable
0:
Read enable
1 :
Read disable
Enableldisable mformation changes accordmg to the setting
of
parameter No.19 "parameter write
inhtbit". When the enable/&sable setting is read disable, ignore the parameter data part and process
it as unreadable.
13- 16