Instruction manual
12.
OPTIONS AND AUXILIARY EQUIPMENT
12.1.2 Junction terminal block (MR-TB20)
(1)
How
to
use the junction terminal block
Always use the junction terminal block (MR-TB2O) with the junction terminal block cable (MR-
J2TBL05M) as a set.
A
connection example is shown below:
Sarvo amplifier
-
Cable clamp
Junction terminal block
(AERSBAN-ESET),
MR-TB20
-
blockcable
=k
-
(MR-J2TBL05M)
Ground the junction terminal block cable on the junction terminal block side with the standard
accessory cable clamp fitting (AERSBAN-ESET).
For
the use
of
the cable clamp fitting, refer
to
Section
12.2.4,
(Z),
(b).
(2) Terminal labels
Among the terminal block labels
for
the junction terminal block, use the two for the MR-J2-A. When
changmg the input signals
in
parameters
No.
43
apply the accessory
signal
seals
to
the labels.
1)
For CNlA
to
48, refer
to
(4)
in
this
section
2) For CN1 B
(3)
Outline drawing
126 (4.96)
117
(4.61)
I,
4
[Unit: mm]
([Unit: in.])
MITS~BISHI
MR-kB20
'
\
2-@5
(0.1
8)
Terminal screw: M3.5
Applicable cable: Max. 2mm2
(Crimping terminal width: 7.2mrn (0.283 in) ma.)
12-
6
and
Section
3.3
and