Instruction manual

6. DISPLAY AND OPERATION
6.8 Test operation mode
The test operation mode is designed to confirm servo operation and not to confirm
machine operation.
In this mode, do not use the servo motor with the machine.
If any operational fault has occurred, stop operation using the forced stop (EMG)
signal.
A CAUTION
POINT I
The Servo Configuration software is required to perform positioning
operation.
6.8.1 Mode change
Call the &splay screen shown after power-on. Choose jog operatiodmotor-less operation in the following
procedure:
I I
is-
0
Press MODE once.
I' I
I .I
0 0
Press UP three times. Press UP five times.
0
0
0
0
Press SET for more than
Press SET for more than 2s.
. . . When this screen
' ' ' When this screen is displayed,
appears, jog feed can motor-less operation can be
+ be performed. 4 performed.
Flickers in the test operation mode.-
6- 12