Instruction manual

6. DISPLAY AND OPERATION
6.7 Output signal forced output (DO forced output)
POINT I
When the servo system is used in a vertical Lft application, turning off
CNP2-9 (electromagnetic brake) wdl release the electromagnetic brake,
causing a drop. Take drop preventive measures on the machme side.
The output signal can be forced odoff independently of the servo status. "ius function is used for output
signal wiring check, etc. Ths operation must be performed in the servo off state (SON signal off).
Operation
Call the display screen shown after power-on.
I I
0
I I
CNlA CNPZ CNlBCNlBCNlBCNlB CNlA CNlA
14
9 18 19 18 19
-a-
0
Press MODE once
0
Press UP twice.
0
Press SET for more than 2 seconds.
] ...... Switch ordoff the signal below the lit segment.
. . Indicates the ON/OFF of the output singal. The correspondences
] between segments and signals are as in the output signals of the
external I/O signal display.
(Lit: ON, extinguished: OFF)
0
Press MODE once.
The segment above CN1 A-pin 18 is lit.
0
Press UP once
CN1 A-pin 18 is switched on.
(CN1 A-pin
18-SG conduct.)
0
Press DOWN once.
CN1 A-pin 18 is switched off,
0
Press SET for more than 2 seconds
6- 11