User`s manual

Wrap the coated parts

with a heat contractile

tube.

(10) To make this product conform to the EMC directive and low voltage

instruction, be sure to use the AD75CK type cable clamp (manufactured

by Mitsubishi Electric) for grounding to the control box.

QD75

AD75CK

20cm(7.88inch)

to 30cm(11.82inch)

Inside control box

Using the AD75CK, you can tie four cables of about 7mm (0.28inch)

outside diameter together for grounding.

(11) The influence of noise may be reduced by installing ferrite cores to the

cable connected to the QD75 as a noise reduction technique.

For the noise reduction techniques related to connection with the servo

amplifier, also refer to the instruction manual of the servo amplifier.

(12) If compliance with the EMC directive is not required, the influence of

external noise may be reduced by making the configuration compliant

with the EMC directive.

For the configuration compliant with the EMC directive, refer to Chapter

9 "EMC AND LOW VOLTAGE DIRECTIVES" of the QCPU User's

Manual (Hardware Design, Maintenance and Inspection).