Specifications

5 - 2
(2) Wiring and preparation
Q61P-A1 Q02HCPU QX42 QY42P Q64
I/O panel
Power
supply
AUX
Servomotor
SW D5C-QD75P
SW D5C-GPPW
RS-232C cable
QD75D4Q62
STOP CHG SON
EMG
POWER
Servo amplifier
QD75 drive module
connection cable
1-axis demonstration machine
SON : Servo ON signal (Servo amplifier)
AHG : External start/switch signal (QD75D4)
STOP : External stop signal (QD75D4)
AUX : Unused
EMG : Emergency stop signal (Servo amplifier)
IMPORTANT
Be sure to turn the power off before replacing the module or wiring.
(3) Powering-on and the switch
1) After mounting modules as shown above and completing the wiring, turn the
Q02HCPU to "STOP", and then turn ON the power switch of the demonstration
machine.
2) After powering on, turn the STOP and CHG switches of the 1-axis demonstration
machine to OFF and the SON switch to ON.
Press the upper side of each switch to turn ON and the lower side to turn OFF.
(ON)