Specifications

4 - 23
(6) Count method (2) (Without zero signals)
This method does not strain a mechanical system or require zero signals, however
it also does not provide high stopping accuracy.
t
Creep speed
Movement amount after near-point dog ONOPR speed
V
The near-point dog must turn OFF
at a sufficient distance away
from the OP position.
Movement amount
after near-point dog ON
Near-point dog OFF
ON
Set in OPR
detailed parameters
OPR direction
Set the direction in which the machine OPR will go at start .
M
Near-point dog
0: Address increment direction at OPR
1: Address decrement direction at OPR
Figure 4.8 OPR direction
IMPORTANT
(1) Setting the OP address to the upper limit side (address increment) or the lower
limit side (address decrement) determines the OPR direction.
[Setting]
(Positive direction) .................................................. 0
• OPR direction
(Negative direction) ................................................ 1
(2) Rotation direction is determined by whether the address increases (the setting
is 0) or decreases (the setting is 1) in the JOG operation in reaction to the
forward run command. Refer to the below.
[Setting]
Forward run pulse (motor forward run CW) ....... 0
Reverse run pulse (motor reverse run CCW) .... 1
Forward run pulse (motor forward run CW) ....... 0
• Rotation direction
Reverse run pulse (motor reverse run CCW) .... 1
0
Address
( address decrement)
(address increment )
1000