Specifications

4 - 22
(4) Stopper method (3) (Without zeroing dogs)
To use this method, caution must be used on the strain to a mechanical system
and torque limit settings. However, a zeroing dog is not required.
t
V
Torque limit
Torque limit valid range
Z
ero signal of
external switch
Stop with stopper
Creep speed
(5) Count method (1) (With zero signals)
This method does not strain a mechanical system and features high precision. To
use this method, caution must be used on the position and length of a near-point
dog, however, it does not have to be used as much as in the near-point dog
method.
t
Creep speed
Movement amount after near-point dog ONOPR speed
V
Zero signal
The near-point dog must turn
OFF at a sufficient distance away
from the OP position.
Movement amount
after near-point dog ON
Near-point dog OFF
ON
First zero signal after moving
the movement amount after
near-point dog ON
Set in OPR
detailed parameters