Specifications

6 - 11
6.5 Writing Data to QD75
This section explains how to write the project data read from the text FD to the QD75.
Refer to Section 5.5.4 for the basic write operation to the QD75.
The example below is to explain the method of writing data only to the required range.
1) Click the [Online] [Write to module [QD75P/QD75D4]] menu.
2) Check the data type to be written in the "Main"
tab.
"Positioning data", "Parameter data" and "Flash
ROM write" are selected as target data types in
this case.
3) Click the "Positioning data" tab.
Designate the range of the axis and positioning
data No. to be written to.
The positioning data No. 1 to 200 of axis 1 is
designated as the writing range in this case.
4) Click the "Parameter data" tab.
Designate the axis to be written to.
The axis 1 is selected as the writing target in
this case.
5) Click the OK
button to write the designated
data and execute the Flash ROM write.
6) Overwrite the contents of Flash ROM.
When "Is it all right?" message appears, click
the Yes
button.
Then, click the OK
button.