User`s manual

7 - 2 7 - 2
MELSEC-Q
7 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL
(c) When the circuit uses the "intelligent function device" for a COMPARISON
command, change the command to a FROM command and a
COMPARISON command.
M0
0
0 D102 K1H0FROMP K51
M0
M0RST
=K0
U0\
G51
M0RST
=K0D102
Data read out
(d) When the circuit uses the "intelligent function device" for a WAND command,
change the command to a FROM command and a WAND command.
M2
0
0
D101 K1H0FROMP K79
M2
Data read out
D0H1WANDP
U0\
G79
D0H1WANDP D101
REMARK
Refer to QCPU (Q mode) User's Manual (Functions and Programs Basic Part) for
the intelligent function devices.
Refer to QCPU (Q mode) Programming Manual (Common Commands Part) for
detail commands used in those programs.
7