Installation manual

3 69-2426—01
3
Link all devices to wireless network
1 Remove cover from wireless receiver.
2 VerifyPOWERlightissolidgreen.
3 PressandreleasetheCONNECT button.
4 IfCONNECTlightdoesnotflash,another
receiver or RedLINK wireless adapter may be in
wirelesssetupmode.Exitwirelesssetupatthe
other device.
M28925
Wireless Setup
Next
M32308
Connect
Back
Wireless Setup
M32307
Done
Connected
Wireless Setup
Link remote controller to wireless network
Zone name
Presss or t to change the name or location of this zone,
then press NEXT.
Example:67=MeetingRoom
See complete zone list on page 8.
PressCONNECT to establish a link to the wireless network.
If E0 or E1 appears, see error codes on page 10.
After a brief pause, the confirmation screen at left should
be displayed to verify that the wireless connection has been
established.
PressDONE to display the home screen.
POWER LED
Solid Green:Poweredandcommunication
is established.
Slow Flashing Green (1 flash/
second): Receiver is powered.
Waitapproximately30secondsfor
communication to be established
between the wireless receiver and the
indoor unit. Check cable connection if
flashing does not stop after 30 seconds.
Fast Flashing Green (5 flashes/second):
Error in communication between
wireless receiver and the indoor unit.
Check cable connection.
CONNECT LED
Flashing Green: In wireless setup
mode.
Solid Green: RedLINK communication
is established.
Yellow:Pleasewait.
Red: RedLINK device is not
communicating.
Flashingstatuslighttimesout
after15minutesofinactivity.Press
CONNECT again if necessary.