Technical Manual

88
Installation
Seal the gap with putty.
Route the cable behind
the remote controller.
Remote controller
cable
Seal the cable access
hole with putty.
Double switch box
Roundhead cross
slot screws
Remote controller
cable
Wood
screw
Remote controller
cable
Thread the cable
through the groove.
2
or
Plate service tool
Front cover
Top case
Protection
Sheet
«Important»
Do not use solderless terminals to connect cables to the terminal block.
Solderless terminals may come in contact with the circuit board and cause malfunctions or damage the controller cover.
Install the bottom case.
■ Installation using a switch box
• Secure at least two corners of the switch box with screws.
■ Direct wall installation
• Thread the cable through the groove.
• Secure at least two corners of the remote controller with screws.
• Be sure to secure top-left and bottom-right corners of the remote controller (viewed from the front) to prevent it from lifting.
(Use molly anchor etc.)
To reduce the risk of electric shock, shorting, or malfunctions,
keep wire pieces and sheath shavings out of the terminal
block.
■ Direct wall installation
• Seal the hole through which the cable is threaded with putty.
Cut out the cable access hole.
■ Direct wall installation (when running the cable along the wall)
• Insert a at-tip screwdriver with a blade width of 4-7 mm (5/32-9/32 inch) or a Plate
service tool into either of the two latches at the bottom of the remote controller, and
move it in the direction of the arrow as shown in the gure at right.
• The top case will come loose from the front cover. Pull the top case toward you to
remove it.
• Cut out the thin-wall part on the front cover (indicated with the shaded area in the
right gure) with a nipper.
(This cutout hole will be used to thread the remote controller cable through, after the
cable is threaded through the groove on the back of the bottom case.)
• Place the top case onto the front cover.
<Direct wall installation><Installation using a switch box>
«Important»
To avoid damage to the controller, do not overtighten the
screws.
To avoid damage to the controller, do not make holes on
the controller cover.
«Notice»
To prevent damage to the circuit board, remove the front cover
from the top case before cutting out a cable access hole.