Technical Manual

74
Service
Function setting (City Multi)
Button operation
Select "Function setting" with the F1 or F2 button, and press the
button.
[
1
]
Select "Service" from the Main menu (refer to page 19), and press the
button.
Make the indoor units' function settings from the remote controller as necessary.
• The following settings should be made only for City Multi units and as necessary.
• Refer to the Installation Manual for how to make the settings for Mr. Slim units.
• Refer to the indoor unit Installation Manual for information about the factory settings of indoor units, function setting
numbers, and setting values.
• When changing the indoor units' function settings, record all the changes made to keep track of the settings.
[
2
]
The Function Setting screen will appear.
Press the F1
or F2 button to move the cursor to one of the following:
M-NET address, function setting number, or setting value.
Then, press the F3
or F4 button to chenge the settings to the desired
settings.
Once the settings have been completed, press the
button.
A screen will appear that indicates that the settings information is being
sent.
OFF
City Multi
Only
Main
Sub
P
Service
unem ecivreS
rosruC
:unem niaM
Test run
Input maintenance info.
Function setting
F1 F2 F3 F4
Set / Conf
Sending data
Cursor
Select:
M-NET address
Function No.
Data
Function
3
32
2
3
32
2
M-NET address
Function No.
Data
Function setting
Function setting
Address
To check the current settings of a given unit, enter the setting for its M-NET
address and function setting number, select Conf for the Function, and
press the button.
A screen will appear that indicates that the settings are being searched for.
When the search is done, the current settings will appear.