Technical Manual

72
Service
Function setting (Mr. Slim)
Button operation
[
1
]
F1 F2 F3 F4
unem ecivreS
rosruC
:unem niaM
Test run
Input maintenance info.
Function setting
Check
Self check
F1 F2 F3 F4
Function setting
Cursor Address
Monitor:
Ref. address
Unit No.
Grp./1/2/3/4/All
F1 F2 F3 F4
Function setting
Cursor Cursor
Request:
Ref. address
Mode 1
Mode 2
Mode 3
Mode 4
Grp.
F1 F2 F3 F4
Function setting
Cursor Cursor
Request:
Ref. address
Mode 7
Mode 8
Mode 9
Mode 10
Unit #1
OFF
Mr.Slim
Only
Main
Sub
P
Service
[
2
]
Set the indoor unit refrigerant addresses and unit numbers with the F1
through F4 buttons, and then press the button to confirm the current
setting.
Select "Function setting" with the F1
or F2 button, and press the
button.
[
3
]
When data collection from the indoor units is completed, the current settings ap-
pears highlighted.
Non-highlighted items indicate that no function settings are made.
Screen appearance varies depending on the "Unit No." setting.
[
4
]
Use the F1 or F2 button to move the cursor to select the mode number,
and change the setting number with the F3
or F4 button.
Select "Service" from the Main menu (refer to page 19), and press the
button.
<Checking the indoor unit No.>
When the
button is pressed, the target indoor unit will start fan operation.
If the unit is common or when running all units, all indoor units for the selected
refrigerant address will start fan operation.
Make the settings for the indoor unit functions via the remote contoroller as nec-
essary.
Select "Function seting" from the Service menu to bring up the Function setting
screen.
Individual items
(Unit No.1 through 4)