Technical Manual

60
Initial setting
Auto mode setting
F1 F2 F3 F4
Cursor Page
Initial setting menu
Main menu:
Auto mode
Administrator password
Language selection
Daylight saving time
F1 F2 F3 F4
Auto mode
Auto mode Yes / No
Select:
Cursor
Main
Sub
Button operation
[
1
]
Move the cursor to the "Auto mode" with the F1 or F2 button, and press
the
button.
Select "Initial setting" from the Main menu (refer to page 19), and press the
button.
[
2
]
Change the setting with the
F3
or
F4
button.
Press the
button to save the changes mode.
Navigating through the screens
• To go back to the Main menu ..................
button
• To return to the previous screen ..............
button
Whether or not to use the Auto (single set point) or Auto (dual set points) mode can be selected by using the button. This
setting is valid only when indoor units with the AUTO mode function are connected.
Auto mode setting : The factory default setting is "Yes".
• Yes: The AUTO mode can be selected in the operation mode setting.
• No: The AUTO mode cannot be selected in the operation mode setting.